since the end of the semester at school is upon me:D If anyone has suggestions or advice, feel free to drop some feedback but right now they will be similar to what svxfiles has on his car. Should be fun, I cannot wait to get these pieces in the mail this week and get started. I ordered the following pieces in which I will be building themĨ Mandrel bent J-bends from Summit 1 3/4' ODĢ Exhaust manifold flanges from Small Car's Vanagon siteĢ 3-1 10' collectors from Stahl Headers in York PA I shimmed the performance bar(torque bar) so it is at the proper height and angle. I then put on a good set of engine mounts I had laying around and placed an extra front subframe on top of the mounts. I figured a nice set of equal length headers would be a nice compliment:D So I picked up an old engine I had at my folk's place and put together a shell of an automatic. Well since the engine build is creeping up on me sooner than later.
